Page Web Française

Subject Routing Date 2008-09-16 Title Webmin - Add Route IP in Linux Server Section Dev Reseau Article For add and handle roads in Linux Server or to change address IP a Gateway, Webmin simplifies the life. Necessary softwares and servers: Operating system: Fedora FC8 FC9 or another Unix. See the article on the installation of Webmin - System and server administration With Webmin, click on the icon Networking then Network Configuration then Routing and Gateways and to play with "data-processing motorway public works". For an Administrator Network, that does without all comments. Routing and Gateways  Routing configuration activated at boot time Default routes  Interface   Gateway   Any eth1 eth0 eth2 lo   Any eth1 eth0 eth2 lo Act as router? Yes No Static routes  Interface   Network  Netmask   Gateway Local routes  Interface  Network  Netmask  Active Routes  Destination  Gateway  Netmask   Interface   192.168.2.0  None  255.255.255.0   eth1  192.168.1.0  None  255.255.255.0  eth0  192.168.16.0  None  255.255.255.0  eth2  172.16.1.0  None  255.255.255.0  eth0  169.254.0.0  None  255.255.0.0  eth2  Default Route   192.168.2.254     eth1  Create active route Route destination Default route Netmask for destination Default Route via Network interface   eth1 eth0 eth2 lo Gateway   Click on the button Save, then on the button:      Click this button to activate the current boot-time interface and routing settings, as they normally would be after a reboot. Warning - this may make your system inaccessible via the network, and cut off access to Webmin. Author Eric Douzet

C-extra.com v. 1.2.0 © 2003-2010, all rights reserved  -  Updated September 02, 2010 Infologism.com